steering problems-turns hard / Giulia 1.3

[73julia]

I think my steering goes too hard and the steering wheel won´t come back into straight position itself after driving a curve. I always have to turn it back. The car itself runs straight without turning left or right and the outer tie-rods both have the same length measurements like shown in my maintenance handbook.
Could just the lowering cause these problems? The car is lowered about 6cm´s in the front....

[siegerdehaan89]

Do you have an bullet cycle steering wheel house (kogelkringloop stuurhuis...?) ??

Then, your bullet's are broken, isn't that the problem, then I don't know.

Other people do know it I think

Greetings, Sieger.

[73julia]

Thanks a lot for your answer! I know what you mean , it´s " Kugelumlauflenkung" in German.
I just checked the measurements in front of the tire and behind it and then saw the difference was too big. I adjusted the tie-rods again and it´s nearly perfect now! You also must know that my daily driver has power steering so first I thought it was worse than it actually had been.....

[KAS]

The car is lowered about 6cm´s in the front....

Dit you check the alignements? And Caster in particular.

[73julia]

Dit you check the alignements? And Caster in particular.

^^
that´s what I did as I saw measurements weren´t ok. Before adjusting my tires were also rubbing on the street and now they don´t do that any more!